DiagramElements-Probe/en: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
Cg (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „Category: Incomplete Category: Empty“) |
Cg (Diskussion | Beiträge) |
||
| Zeile 1: | Zeile 1: | ||
Probes can be placed into a diagram to monitor values appearing at a step's output pin. |
|||
[[Category: Incomplete]] |
|||
They can be configured to check those pin values against a wide number of attributes |
|||
(values are in a range, values are increasing, decreasing, below or above a limit etc.) |
|||
The parameters (i.e. limits or range bounds) can either be efined statically, |
|||
or recorded by a prototypical "good" run through the testsuite. |
|||
For this, probes can be set into one of three modes: |
|||
* inactive - probes are disabled completely |
|||
* recording - probes will record incoming values and adjust their check-parameter(s) |
|||
* checking - probes will monitor incoming values and check them against their check-parameter(s) |
|||
Probes are placed into the diagram via diagram editor's the pop-up menu. |
|||
[[Category: Empty]] |
[[Category: Empty]] |
||
Version vom 30. November 2017, 14:24 Uhr
Probes can be placed into a diagram to monitor values appearing at a step's output pin. They can be configured to check those pin values against a wide number of attributes (values are in a range, values are increasing, decreasing, below or above a limit etc.)
The parameters (i.e. limits or range bounds) can either be efined statically, or recorded by a prototypical "good" run through the testsuite.
For this, probes can be set into one of three modes:
- inactive - probes are disabled completely
- recording - probes will record incoming values and adjust their check-parameter(s)
- checking - probes will monitor incoming values and check them against their check-parameter(s)
Probes are placed into the diagram via diagram editor's the pop-up menu.
