HelpWizard Pages Start Web Test6.1/en: Unterschied zwischen den Versionen

Aus expecco Wiki (Version 2.x)
Zur Navigation springen Zur Suche springen
 
(5 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt)
Zeile 1: Zeile 1:
<strong> Recording of the disconnection and closing the web browser </strong>
<strong> Recording of the disconnect and close of the web browser </strong>


[[Datei:arrowleft.png|link=HelpWizard Pages Start Web Test6/en|back]]
[[Datei:arrowleft.png|link=HelpWizard Pages Start Web Test6/en|back]]
[[Datei:arrowright.png|link=HelpWizard Pages Start Web Test7/en|next]]
[[Datei:arrowright.png|link=HelpWizard Pages Start Web Test7/en|next]]


<br>


The disconnect and closing of the web browser should be recorded as a separate
The disconnect and closing of the web browser should be recorded as a separate
action block. This will usually be placed at the very end of a longer testplan.
action block.


The disconnect action can be saved from within the GUI browser,
This can either be saved from within the GUI browser or by creating a new compound action in the tree with [[Datei:neuer_aktionsbaustein.png]], and dragging the disconnect action block into its network.
or created in the tree with [[Datei:neuer_aktionsbaustein.png]], and then dragging the disconnect action block into its network.


[[Datei:connection.png]]
[[Datei:connection.png]]
Zeile 15: Zeile 15:
Use the same connection name as was used in the connect action.
Use the same connection name as was used in the connect action.


[[Datei:Disconnect-Baustein hinzugefügt.png]]
[[Datei:Disconnect-Baustein hinzugefügt.png|400px]]






[[Category: HelpWizard]]
[[Category: HelpWizard/en]]
[[Category: HelpWizard WebTest]]
[[Category: HelpWizard WebTest/en]]

Aktuelle Version vom 20. März 2022, 23:16 Uhr

Recording of the disconnect and close of the web browser

back next


The disconnect and closing of the web browser should be recorded as a separate action block. This will usually be placed at the very end of a longer testplan.

The disconnect action can be saved from within the GUI browser, or created in the tree with Neuer aktionsbaustein.png, and then dragging the disconnect action block into its network.

Connection.png

Use the same connection name as was used in the connect action.

Disconnect-Baustein hinzugefügt.png



Copyright © 2014-2024 eXept Software AG