HelpWizard Pages Start Web Test7/en: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
(Die Seite wurde neu angelegt: „<strong> Web Test 7 </strong> link=HelpWizard Pages Start Web Test6/en|back Datei:arrowright.png|link=HelpWizard Pages Start Web T…“) |
Cg (Diskussion | Beiträge) |
||
| (15 dazwischenliegende Versionen von 3 Benutzern werden nicht angezeigt) | |||
| Zeile 1: | Zeile 1: | ||
<strong> |
<strong> Create a testplan </strong> |
||
| ⚫ | |||
| ⚫ | |||
Finally, create a testplan with: [[Datei:TestplanAnlegen.png]] in the tree. |
|||
Then drag & drop the connect action block followed by the individual test actions into it. |
|||
The last item in the list usually closes the browser and disconnects. |
|||
It is a good idea to ensure that each individual testcase leaves the browser in a defined state (usually in an entry page), |
|||
so that you can later enable/disable individual test cases. I.e. the followup testcase should see the same initial page independent of whether the previous testcase was executed or not. |
|||
(of course, this may not always be possible; then, it might be good to put those correllating testcases into a separate sub testplan) |
|||
| ⚫ | |||
| ⚫ | |||
<br /> |
|||
[[HelpWizard Pages Start/en|Go back to Start]] |
|||
[[Category: HelpWizard/en]] |
[[Category: HelpWizard/en]] |
||
[[Category: HelpWizard WebTest]] |
[[Category: HelpWizard WebTest/en]] |
||
Aktuelle Version vom 19. November 2020, 14:38 Uhr
Create a testplan
Finally, create a testplan with: 
in the tree.
Then drag & drop the connect action block followed by the individual test actions into it. The last item in the list usually closes the browser and disconnects.
It is a good idea to ensure that each individual testcase leaves the browser in a defined state (usually in an entry page), so that you can later enable/disable individual test cases. I.e. the followup testcase should see the same initial page independent of whether the previous testcase was executed or not. (of course, this may not always be possible; then, it might be good to put those correllating testcases into a separate sub testplan)
