HelpWizard Pages Start Web Test6.1/en: Unterschied zwischen den Versionen

Aus expecco Wiki (Version 25.x)
Zur Navigation springen Zur Suche springen
Inhalt gelöscht Inhalt hinzugefügt
Angruber (Diskussion | Beiträge)
Keine Bearbeitungszusammenfassung
Keine Bearbeitungszusammenfassung
 
(9 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt)
Zeile 1: Zeile 1:
<strong> Web Test 6.1 </strong>
<strong> Recording of the disconnect and close of the web browser </strong>


[[Datei:arrowleft.png|link=HelpWizard Pages Start Web Test6/en|back]]
[[Datei:arrowleft.png|link=HelpWizard Pages Start Web Test6/en|back]]
[[Datei:arrowright.png|link=HelpWizard Pages Start Web Test7/en|next]]
[[Datei:arrowright.png|link=HelpWizard Pages Start Web Test7/en|next]]


<br>


The disconnect and closing of the web browser should be recorded as a separate
To disconnect the Connection you need a new component [[Datei:neuer_aktionsbaustein.png]].
action block. This will usually be placed at the very end of a longer testplan.

<br>

Drag and drop the disconnect component into the network.
<br>


The disconnect action can be saved from within the GUI browser,
or created in the tree with [[Datei:neuer_aktionsbaustein.png]], and then dragging the disconnect action block into its network.


[[Datei:connection.png]]
[[Datei:connection.png]]


Use the same connection name as was used in the connect action.
<br>

Use the same connection name like the connection component.

<br>


[[Datei:Disconnect-Baustein hinzugefügt.png]]
[[Datei:Disconnect-Baustein hinzugefügt.png|400px]]






[[Category: HelpWizard]]
[[Category: HelpWizard/en]]
[[Category: HelpWizard WebTest]]
[[Category: HelpWizard WebTest/en]]

Aktuelle Version vom 20. März 2022, 23:16 Uhr

Recording of the disconnect and close of the web browser

back next


The disconnect and closing of the web browser should be recorded as a separate action block. This will usually be placed at the very end of a longer testplan.

The disconnect action can be saved from within the GUI browser, or created in the tree with , and then dragging the disconnect action block into its network.

Use the same connection name as was used in the connect action.



Copyright © 2014-2024 eXept Software AG